How to Use the VisibleDust 8mm Sensor Brush for Chamber Cleaning

Quick answer

Use the VisibleDust 8mm Sensor/Chamber Cleaning Brush with SCF technology to gently sweep dust from the sensor chamber. Keep separate brushes for sensor and chamber to avoid cross-contamination.

Step-by-step chamber cleaning steps

1. Prepare your camera and workspace: Power off the camera and remove the lens. Set the camera to sensor cleaning mode (usually found in the menu). Work in a low-dust area, ideally near a still-air source. Do not blow into the chamber; that can push dust deeper.
2. Inspect the brush tip: Uncap the VisibleDust 8mm brush and check the bristles for any visible debris or oil. If dirty, clean the brush per manufacturer instructions before use. A dirty brush can smear particles rather than remove them.
3. Gently sweep the chamber: Hold the brush vertically and insert it into the chamber. Use light, one-direction strokes along the chamber walls and corners. Rotate the brush slowly to cover all surfaces. Do not press the brush against the sensor itself—keep it focused on the chamber walls.
4. Remove and inspect: Withdraw the brush carefully. Hold it under a bright light to see collected dust. If dust remains in the chamber, repeat steps 2-3 with a fresh brush stroke. If you see dust on the brush, it worked. Do not reinsert a heavily loaded brush without cleaning it first.
5. Replace lens and test: Reattach the lens, power on the camera, and take a test shot of a plain white surface at f/16 or f/22. Review the image for any remaining dust spots. If spots appear, repeat the chamber cleaning before moving to sensor cleaning.

Product spotlight

• VisibleDust 8mm Sensor/Chamber Cleaning Brush: Equipped with SCF technology. Use on Sensor or Chamber Area (Use separate brush). Clean away dust in hard to reach places. SCF technology attracts and holds dust particles, while the 8mm width reaches tight chamber corners without scratching the sensor.